Security - Acer AO722 Service Manual

Security

The Security screen contains parameters that help safeguard and protect your computer from unauthorized
use.
Information Main
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Power on password
↑↓
F1 Help
←→
ESC Exit
The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
Parameter
Supervisor Password Is
User Password Is
Set Supervisor Password
Set User Password
Power on password
NOTE: When you are prompted to enter a password, you have three tries before the system halts. Don't forget
your password. If you forget your password, you may have to return your notebook computer to your
dealer to reset it.
22
InsydeH20 Setup Utility
Security Boot
Clear
Clear
[Enabled]
Select Item F5/F6
Select Menu Enter
Shows the setting of the Supervisor password
Shows the setting of the user password.
Press Enter to set the supervisor password. When
set, this password protects the BIOS Setup Utility
from unauthorized access. The user can not either
enter the Setup menu nor change the value of
parameters.
Press Enter to set the user password. When user
password is set, this password protects the BIOS
Setup Utility from unauthorized access. The user can
enter Setup menu only and does not have right to
change the value of parameters.
Defines whether a password is required or not while
the events defined in this group happened. The
following sub-options are all requires the Supervisor
password for changes and should be grayed out if the
user password was used to enter setup.
Exit
Item Specific Help
Install or Change the
password and the length
than eight words.
Change Values
Select SubMenu
Description
Rev. 3.5
F9 Setup Default
F10 Save and Exit
Option
Clear or Set
Clear or Set
Enabled or
Disabled
Chapter 2