Table of Contents
Advertisement
2.
The following is displayed:
Select "change/show characteristics of a tape drive"
3.
A pop-up window is displayed:
Select the tape drive you wish to change. The example above shows an LTO FC tape drive as
available for selection.
4.
The following details are displayed:
Check the following values and change them if necessary:
• BLOCK Size (0=variable length) = 0
• Use EXTENDED file marks = "no"
• RESERVE/RELEASE support = "yes"
• Set timeout for the READ or WRITE command = 1200
Press the Enter key ("Do") to apply the changes.
Refer to
http://www.hp.com/go/connect
Once device files have been configured, you should confirm that your new tape drive is working
properly.
"Verifying the
a sample file to test your installation.
for up-to-date information on supported applications
installation" on page 31 provides instructions on backing up and restoring
Volume 5: UNIX, Linux and OpenVMS configuration guide
23
Advertisement
Table of Contents
