Connecting Peripheral Equipment - Siemens SIMATIC HMI OP 77B Operating Instructions Manual

Release 03/2004

4.4 Connecting Peripheral Equipment

Connection configuration
Figure 4–5 Connecting peripheral equipment
• Interfaces: USB
• Interface description – refer to Chapter 1.5.
Notice
Nominal load of the interface
The load capacity of the USB connection is limited to
100 mA. Avoid applying higher loads. Otherwise,
functional faults can occur on the peripheral equipment
connected.
The following peripheral equipment can be connected:
• Printer
Note
Documentation on peripheral equipment
Also observe the documentation supplied with the
printer when connecting it.
Operating Instructions (Compact) OP 77B
6AV6691-1EA01-0AB0
& R Q Q H F W L Q J W K H 2 3   %
USB
4–7