Disasembling The Veriton 9100; Opening The Housing - Acer Veriton 9100 Service Manual

Disassembling the Veriton 9100

Opening the Housing

This section tells you how to open the housing cover when you need to install additional components inside
the system unit.
CAUTION: Before you proceed, make sure that you have turned off the system and all peripherals connected
to it.
Removing the Housing Cover
1. Turn off the system power and unplug all cables.
2. Place the system unit on a flat, steady surface.
3. Remove the four screws of the right panel using a screwdriver. Set the screws aside, you will need them
when replacing the right panel of the unit.
4. Slide the right panel out and then gently pull it outward to detach it from the housing. Do the same for the
left panel.
45 Chapter 3