Post Error And Beep Codes - Acer Aspire G7700 Series Service Manual

POST Error and Beep Codes

NOTE: Perform the FRU replacement or actions in the sequence shown in FRU/Action column, if the FRU
replacement does not solve the problem, put the original part back in the computer. Do not replace a
non-defective FRU.
The error messages in the following table indicate the BIOS signals on the screen and the error symptoms
classified by functions. If the symptom is not included on the list, please refer to "Undetermined Problems".
NOTE: Most of the error messages occur during POST. Some of them display information about a hardware
device, e.g., the amount of memory installed. Others may indicate a problem with a device, such as the
way it has been configured.
NOTE: If the system fails after you make changes in the BIOS Setup Utility menus, reset the computer, enter
Setup and install Setup defaults or correct the error.
POST Code (Hex)
FFh
03h
FFh
03h
03h
03h
FFh
03h
FFh
04h
FFh
FFh
FFh
05h
06h
FFh
FFh
07h
07h
Chapter 4
Turn On LPC Positive Decode
Init At Start POST_FAR
Init At Start POST_FAR
Allocate EBDA_FAR
Init At Start POST_FAR
Cp Init At Start POST_FAR
Init At Start POST_FAR
NB_Init At Start POST_FAR
Cp Init At Start POST_FAR
SB_Init At Start POST_FAR
Cp Init At Start POST_FAR
SB PCIE_Init At Start POST_FAR
SB_Init At Start POST_FAR
OEM_Init At Start POST_FAR
Cp Init At Start POST_FAR
OEM BOARD_A_Cp Init At Start POST_FAR
Cp Init At Start POST_FAR
Init CMOS_FAR
Init CMOS Based Data_FAR
Init CMOS_FAR
Disable Smithfield TM2_FAR
Init CMOS_FAR
Init PIC 8259_FAR
Init INT System_FAR
Init INT System_FAR
Init Timer 8254_FAR
Init INT System_FAR
Install POST INT 1Ch Handler_FAR
Init Timer 8254_FAR
OEM BOARD_B_Init CPU_FAR
Init CPU_FAR
init_bup6_data_area_FAR
Init CPU_FAR
Fixup CPU Post PTR_FAR
Init CPU_FAR
POST Routine Description
69