24
Fan power connectors
The fan power connectors (CPUFAN and SYSFAN1-5) support system cooling fan
with +12V. When connecting the wire to the connectors, always note that the
red wire is the positive and should be connected to the +12V; the black wire is
ground and should be connected to GND.
Important:
utility that will automatically control the these fan speed according to the
actual CPU and system temperature. Fan/heat sink with 3 or 4 pins are both
available for CPUFAN.
Front panel connectors
The front panel connectors (F_PANEL1) are for electrical connection to the front
panel switches and LEDs.
F_PANEL1 front panel pin definition
PIN
SIGNAL
1
Storage_LED +
2
FP PWR/SLP
3
Storage_LED -
4
FP PWR/SLP
5
RST_SW -
6
PWR_SW+
CPUFAN supports fan control. You can install Dual Core Center
DESCRIPTION
Hard disk LED pull-up
MSG LED pull-up
Hard disk active LED
MSG LED pull-up
Reset Switch low reference pull-down to GND
Power Switch high reference pull-down to GND
2 System tour