Table of Contents
Advertisement
Troubleshooting
Alarm Code
High Temperature
Alarm
Water Filter Alarm
Open Door Alarm
Long term power
loss Alarm
Bluezone® Bulb
Replacement
Indicator
Clean Condenser
Coil Indicator
Service Information
If service is required, call your authorized service agency.
Have the following information readily available:
• Model number
• Serial number
• Date purchased
• Name of dealer from whom purchased
Clearly describe the problem that you are having. If you are unable to obtain the name of an authorized service agency, or if you continue to
have service problems, contact Viking Range at (888) 845-4641 or write to:
Record the information indicated below. You will need it if service is ever required. The serial number and model numbers for your refrigerator
are located on the upper wall, behind the lighting:
Model No. __________________________________________________ Serial No. ______________________________________________
Date of Purchase_____________________________________________ Date Installed __________________________________________
Dealer's Name ______________________________________________________________________________________________________
Address ___________________________________________________________________________________________________________
__________________________________________________________________________________________________________________
If service requires installation of parts, use only authorized parts to insure protection under the warranty.
Code Explanation
Alarm will sound and display will fl ash when temperature exceeds the high temperature
allowed. Press alarm button. Sound will mute but display will continue to fl ash until normal
maximum temperature is reached.
When it is time to change the water fi lter, the water fi lter button will illuminate to blue. After
fi lter has been changed, the illuminated button will go off .
If any door or drawer is opened longer than 3 minutes, the open door alarm will sound.
Closing the door will turn the open door alarm off .
After a long term power loss, the temperature will display a power loss. Press any key to clear
the power loss indicator
When the Bluezone® bulb needs replacement, the thin blue Bluezone® indicator strip will
appear along the bottom of the refrigerator display. After replacing the bulb, press and hold
the Refrigerator Selector button for 3 seconds to clear display.
The refrigerator temperature display will blink "CL" when it is time to clean the condenser coils.
VIKING RANGE, LLC
PREFERRED SERVICE
111 Front Street
Greenwood, Mississippi 38930 USA
Keep this manual for future reference.
17
Advertisement
Table of Contents
