Table of Contents
Advertisement
MAINTENANCE
The Bush Hog 100 Series is a rugged, heavy duty
Blade that will perform satisfactorily with the
following preventive maintenance.
Lubricate the Moldboard Pivot Pin and the
Moldboard Tilt Pin after every 10 hours of
operation. Decals are placed in locations of grease
fittings. See illustration.
If the Planer Wheel Assembly is used (Accessory
Equipment), Wheel Bearings are packed at the
factory with a heavy bodied grease. A Grease
Fitting is provided. It is recommended that the
Bearings be greased after every 10 hours of use.
Also, there is a Grease Fitting provided at the pivot
location of the Caster Fork. Grease after every 10
hours of use.
If the Ratchet Jack is used in place of the Hydraulic
Cylinder on the Planer Wheel, grease the threads
of the Jack occasionally.
Replace excessively worn Grader Blade when
Ditching. A badly worn cutting edge increases the
strain on the Blade and the tractor.
100 Series 05/10
Maintenance Section 5-2
© 2010 Alamo Group Inc.
Advertisement
Table of Contents
