Installation Of Upper Unit - Hoshizaki KM-590DWJ Instruction Manual

6) Level the icemaker and storage bin in both the
left-to-right and front-to-rear directions. Adjust the
storage bin legs to make the icemaker level.7
7)Replace the panels and storage bin baffle in their
correct positions unless you are installing an upper
unit. If installing an upper unit, see "II.E. Installation
of Upper Unit."
E. Installation of Upper Unit
1) See "II.D. Setup" for the lower unit installation.
2) Remove the top panel and the top insulation of the
lower unit. The top panel and the top insulation of
the lower unit are not required when installing an
upper unit.
3) Unpack the upper unit and remove the shi1pping
carton, tape, and packing material.
4) Remove the panels of the upper unit.
5) Stack the upper unit on top of the lower unit.
6) Secure the upper unit to the lower unit using the
2 mounting brackets and the bolts provided. See
Fig. 5.
Icemaker
(Upper Unit)
Icemaker
(Lower Unit)
Bin
Fig. 5
7) Remove the bin control cable bracket from inside
the upper unit. See Fig. 6. Leave the upper unit's bin
control assembly in its original position. It will not be
used.
8) Route lower unit wire harness connector B through the
hole in the bottom of the upper unit. Route the wiring
through the bushing in the bin control cable bracket,
then through the wire saddles.
9) Connect lower unit wire harness connector B to upper
unit wire harness connector A.
Note: Wire harness is connected to the control board
red K4 connector.
10) Make sure the wire harnesses are secured in the wire
saddles and do not interfere with any components.
11) Secure the bin control cable bracket.
12) Replace the panels and storage bin baffle in their
correct positions.
Bolts
Mounting
Brackets
9
Upper Unit Connection Overview
Lower Unit Wire Harness Connector B/
Upper Unit Wire Harness Connector A
Upper Unit Wire Harness
Connector B (not used)
Bin Control
Cable Bracket
Upper Unit Connection Detail
Upper Unit Wire Harness
Connector B (not used)
Lower Unit Wire Harness Connector B
See "II.D. Setup" for
Lower Unit Connection
Fig. 6
ENGLISH
Upper Unit Wire Harness
Control Board Red
K4 Connector
Lower Unit
Wire Harness
Wire Saddle
Control
Board
Red K4
Connector
Upper Unit
Wire Harness
Connector A
Control Board Red
K4 Connector