Cleaning The Condenser; Cleaning The Humidity Sensor - Matsui MCD7W19E Installation Instructions Manual

Cleaning the Condenser

Allow the condenser to cool down before removing it.
1. Turn off the dryer and remove the plug
from the mains. Allow the dryer to cool
down.
2. Open the condenser flap on the front
of the dryer.
3. Release the blue clips.
4. Gently pull the condenser out of the
housing.
5. Remove any dust or fluff from
the condenser, you can rinse the
condenser under a tap to clean
between all the metal fins.
6. Dry the condenser and slide it back
into the housing and close the blue
clips.
7. Close the condenser flap on the front
of the dryer.

Cleaning the Humidity Sensor

If you look inside the drum you will see 2 metal strips. They are at the front of the drum behind
the lint filter. These need cleaning from time to time at least 4 times a year.
• Allow the dryer to cool down. Open the door, you might want to remove the lint filter so you
can access the sensor easier.
• Wipe the sensor with a damp cloth, remove any lint or fluff is there is any stuck to the sensor.
Do, not use any cleaning products when cleaning the sensor.
Matsui Condenser Tumble Dryer MCD7W19E Manual.indb 45
45
14/02/2019 16:57