Emerson LD280EM4 Owner's Manual page 40

Camera Angles
DVD
Some DVD may contain scenes which have been shot simultaneously
from various Angles. You can change the Camera Angle if
on the screen. If ANGLE ICON is set to OFF in OTHERS menu,
not appear. ➟ p.33
1
During Playback, press MODE repeatedly until
2
Use repeatedly until your desired Camera Angle appears.
1 / 8 (ANGLE)
3
Press BACK to exit.
Black Level Setting
DVD
Adjust the Black Level to make the dark areas of the TV picture brighter.
1
During Playback, press MODE repeatedly until
2
Press to adjust the Black Level.
ON
Makes the Dark Areas brighter.
OFF Shows the Original Picture as recorded.
3
Press BACK to exit.
Note(s)
• The setting will be kept even if the unit goes into Standby Mode.
Stereo Sound Mode
CD
This unit allows you to select a Sound Mode during CD Playback.
1
During Playback, press SAP / AUDIO repeatedly until the desired
Sound Mode appears.
2
Each time you press SAP / AUDIO, the Sound Mode changes as
follows.
STEREO
Stereo Sound with Left and Right Channels.
L-ch
Left Channel Sound Only.
R-ch
Right Channel Sound Only.
Note(s)
• Virtual Surround cannot be changed when the Sound Mode is set to either L-ch or R-
ch.
Virtual Surround
You can enjoy Virtual Surround on your 2 channel Stereo System.
1
During Playback, press MODE repeatedly until
2
Press to select the Sound Level.
1
Natural Effect.
2
Emphasized Effect.
OFF
No Effects (original sound).
3
Press BACK to exit.
Note(s)
• The Setting will be kept even if the unit is Turned Off.
• For Audio CD, Virtual Surround will not be effective if the Sound Mode is set to
something other than STEREO.
Stereo Sound Mode. ➟ p.40
• Turn down the level or select OFF if the Sound is distorted.
appears
will
appears.
Angles can be varied on
the displayed number
appears.
appears.
Marker Setup
This feature allows you to assign a specific point on a disc to be called
back later.
To set a Marker
1
During Playback, press MODE repeatedly until
2
Use repeatedly until Marker Search Menu appears.
3
Use to select an available Marker within 60 seconds.
4
When the Playback reaches the point at which you want to set a
Marker, press OK.
• Marker is now set.
5
Press BACK to exit.
To return to the Marker later
1
Repeat steps 1-2 in To set a Marker. Use
desired Marker.
2
Press OK at the desired Marker to Restart Playback from the
specific point which you set.
Note(s)
• Marker Search Menu will disappear in about 60 seconds when there is no Input.
• You can Mark up to 10 points.
• To Clear a Marker, select the Marker to be Cleared, and then press CLEAR.
• Ejecting the disc or turning off the Power will Erase all Markers.
• Selecting at step 3 in the section (To set a Marker) will also Erase all Markers.
40
English
/ appears.
to select the