Wasp Delta 4070 Industrial X Series Manual Of Use And Maintenance page 71

8
USE OF THE PRINTER
8
P
remises
ASSEMBLE ZEN EXTRUDER
1. Plug the connector to the filament driver
2. Fix the six suport arms on the effector
3. Tighten the 6 screws with a 3mm Allen key
4. Plug the remaining connectors to the extruder
5. Fix the central band of the extruder
6. Put a cable tie on the extruder to fix it
7. Fix the PTFE pipes on the extruder
8. Turn on the machine
9. Start the automatical calibration as described in paragraph 6.4 "Autocalibration"
10. Load the filament as described in paragraph 6.5 "Loading the filament"
fig 8.9 n fig 8.9 o
© WASP S.r.l.
71