Introduction; Safety Precautions; Safety Signs And Messages - BKI FH-28WM Service Manual

Ventless Hood System
Congratulations! You have chosen BKI's Ventless Hood system, a state-of-the-art unit that filters grease
laden air and returns it to the room.
The BKI name and trademark on this unit assures you of the finest in design and engineering -- that it has
been built with care and dedication -- using the best materials available. Attention to the operating
instructions regarding proper operation, installation and maintenance will result in long lasting
dependability to insure the highest profitable return on your investment.

Safety Precautions

Always follow recommended safety precautions listed in this manual. Below is the safety alert symbol.
When you see this symbol on your equipment, be alert to the potential for personal injury or property
damage.

Safety Signs and Messages

The following Safety signs and messages are placed in this manual to provide instructions and identify
specific areas where potential hazards exist and special precautions should be taken. Know and
understand the meaning of these instructions, signs, and messages. Damage to the equipment, death or
serious injury to you or other persons may result if these messages are not followed.

Introduction

PLEASE READ THIS ENTIRE MANUAL BEFORE OPERATING THE UNIT. If you
have any questions, please contact your BKI Distributor. If they do not answer
your questions, contact the BKI Technical Service Department, toll free: 1-800-
927-6887. Outside the U.S., call 1-864-963-3471.
This message indicates an imminently hazardous situation, which, if not avoided,
will result in death or serious injury.
This message indicates a potentially hazardous situation, which, if not avoided,
could result in death or serious injury.
This message indicates a potentially hazardous situation, which, if not avoided,
may result in minor or moderate injury. It may also be used to alert against
unsafe practices.
This message is used when special information, instructions or identification are
required relating to procedures, equipment, tools, capacities and other special
data.
2
Introduction