Table of Contents
Advertisement
Setting items
*9
Panel Alignment
Uniformity
Notes
*1: Since the Keystone/Warping/Linearity adjustment is an electronic correction, the image may
deteriorate.
*2: Depending on the position adjusted with the lens shift feature, the aspect ratio of the image may
change from the original or projected image may be distorted with Keystone adjustment.
*3: The brightness and color of the projected image may not match completely, even after you adjust
"Brightness" and "Color."
*4: You cannot adjust anything other than the targeted adjustment zones in "Black Level Adj."
*5: When selecting the correction zone of "Black Level Adj.," the targeted correction zone flashes
twice.
*6: When entering the Zone Fitting adjustment, the whole screen flashes twice to indicate the
division state of the area.
*7: If the Screen Aspect is set to 16:10 and input signal is 16:10 or 16:9, the image will be projected
at the correct aspect. This function is not available when displaying two pictures.
*8: When the projected image is displayed smaller than the entire projection surface using the
Aspect or Screen Aspect setting, blanking may not be applied.
*9: Depending on the adjustment value of "Panel Alignment," the color and resolution may be
changed.
Description
This feature allows you to adjust the gaps in the color of characters or the
picture.
When set to "On," "Adjust Color" and "Pattern Color" can be assigned and
adjusted.
Adjust Item: Selects how to make adjustments from below.
Shift: Shifts the whole picture and makes adjustments.
Zone: Selects the desired range and makes adjustments.
Adjust Color: Assigns the desired color to adjust the gaps in color. Select
"R" (Red) or "B" (Blue) to make adjustments based on "G" (Green).
Pattern Color: Select "R/G" (Red and Green) or "R/G/B" (White, all
colors) when "Adjust Color" is "R" (Red). Select "B/G" (Blue and Green)
or "R/G/B" (White, all colors) when the "Adjust Color" is "B" (Blue).
Adjust: The shift adjustment and zone adjustment of the color selected in
"Adjust Color" can be made with V/v/B/b keys.
Reset: The panel alignment settings are initialized to their factory preset
values.
This feature allows you to adjust color uniformity.
Select the appropriate brightness level from level 0 to level 11. Also, select
the desired range to adjust the color.
Level: Select the brightness level (0-11) to adjust the brightness of the
screen.
Area: Top Left: Select the top-left point to specify the adjustment range.
Area: Bottom Right: Select the bottom-right point to specify the
adjustment range.
R: Adjusts the red level in the selected range.
G: Adjusts the green level in the selected range.
B: Adjusts the blue level in the selected range.
Reset: Resets all of the adjusted values.
38
Advertisement
Table of Contents
