Yamaha RemoteLive Disklavier DKC-850 Connection Manual page 3

Important
• Be sure to backup the data on your existing control unit to a floppy disk before connecting.
• Please keep your original control unit for future maintenance.
1
Turn on your piano, and reset settings on your control unit
to its factory default.
For details on setting, refer to your piano's owner's manual.
2
Turn off your piano, and disconnect the power cable from
the AC wall outlet.
3
Disconnect the control cable from the TO CONTROL
CABLE FOR PIANO connector on the rear panel of your
control unit.
Loosen the two screws attached to the connector using a
screwdriver.
4
Connect the supplied conversion cable to the control cable
disconnected in step 2.
Tighten the two screws attached to the connector using a
screwdriver.
5
Connect the supplied conversion cable to the TO PIANO
connector on the rear panel of DKC-850.
Tighten the two screws attached to the connector using a
screwdriver.
6
Connect monitor speakers to the OUTPUT jacks on the rear
panel of DKC-850.
7
Connect the supplied AC adaptor to the DC-IN 12V
connector on the rear panel of DKC-850.
8
Connect the supplied power cable to the AC adaptor.
9
Connect the power cable extended from your piano and the
AC adaptor to the AC wall outlet.
The connection completed.
Turn on DKC-850, and set the piano type.
3
Note:
The location of the TO CONTROL
CABLE FOR PIANO connector
varies depending on the piano model.
Attention:
DKC-850 does not work properly if
the control cable is connected
directly to it. Use the supplied
conversion cable to connect your
piano and DKC-850.

See "Connecting Monitor Speakers"
on page 4.

See "Setting the Type of Your Piano"
on page 5.