Dic Warnings And Messages - Suzuki 2008 XL7 Owner's Manual

INSTRUMENT PANEL
Messages" in this section for more infor-
mation.
If the tire pressure display shows dashes
instead of a value, there may be a problem
with your vehicle. If this consistently
occurs, see your dealer for service.
BATTERY
Press the vehicle information button until
BATTERY displays. This display shows the
current battery voltage. If the voltage is
normal, the display will show NORMAL. If
the voltage is low or high, the display will
show LOW or HIGH. Your vehicle's charg-
ing system regulates voltage based on the
state of the battery. The battery voltage
may fluctuate when viewing this informa-
tion on the DIC. This is normal. Refer to
"Charging System Light" in this section for
more information.
If there is a problem with the battery charg-
ing system, the DIC will display SERVICE
BATTERY CHARGING SYSTEM. Refer to
"SERVICE BATTERY CHARGING SYS-
TEM" under "DIC Warnings and Mes-
sages" in this section. Also, refer to
"Electric Power Management" in this sec-
tion for more information.
3-29
LEARN REMOTE KEY
This display allows you to match the
Remote Keyless Entry (RKE) transmitters
to your vehicle. To match an RKE transmit-
ter to your vehicle:
1) Make sure the vehicle is in PARK (P).
2) Press the vehicle information button
until LEARN REMOTE KEY PRESS
TO BEGIN displays.
3) Press the set/reset button until.
REMOTE KEY LEARNING ACTIVE is
displayed.
4) Press and hold the lock and unlock but-
tons on the first transmitter at the same
time for about 15 seconds.
A chime will sound indicating that the
transmitter is matched.
5) To match additional transmitters at this
time, repeat Step 3.
Each vehicle can have a maximum of
four transmitters matched to it.
6) To exit the programming mode, you
must cycle the key to LOCK/OFF.
Blank Display
This display shows no information.
FEATURE SETTNGS (Settings):
PRESS TO SELCT (Serect)
This display allows you to personalize the
feature settings on your vehicle. Refer to
"DIC Vehicle Personalization" in this sec-
tion for more information.

DIC Warnings and Messages

Messages are displayed on the DIC to
notify the driver that the status of the vehi-
cle has changed and that some action may
be needed by the driver to correct the con-
dition. Multiple messages may appear one
after another. Some messages may not
require immediate action, but you can
press the set/reset button to acknowledge
that you received the messages and to
clear them from the display. Pressing any
of the DIC buttons also acknowledge and
clear any messages. Some messages
cannot be cleared from the DIC display
because they are more urgent. These
messages require action before they can
be cleared. You should take any mes-
sages that appear on the display seriously
and remember that clearing the messages
will only make the messages disappear,
not correct the problem. The following are
the possible messages that can be dis-
played and some information about them.
ALL WHEEL DRIVE OFF
If your vehicle has the All-Wheel Drive
(AWD) system, this message displays
along with the All-Wheel Drive Disabled
light when the rear drive system is over-
heating. This message turns off when the
rear drive system cools down. If the warn-
ing message stays on for a while, you
need to reset the warning message. To
reset the warning message, turn the igni-
tion off and then back on again. If the mes-
sage stays on, see your dealer right away.