Illuminated Entry; Vehicle Finder Function; Sounding A Panic Alarm; Selecting Audible Signal Operation - Subaru 2007 Forester Owner's Manual

A8110BE.book 8 ページ ２００６年６月２３日 金曜日 午後１時３２分
2-8
Keys and doors

Illuminated entry

The interior (dome and cargo area) light
will illuminate when the " " button is
pressed. This light stay illuminated for ap-
proximately 30 seconds if any of the doors
or the rear gate is not opened.
If the " " button is pressed before 30
seconds have elapsed, this light will go
out.
To activate this function, set the following
interior light switches to the indicated po-
sitions:
Dome light: Middle position
Cargo area light: DOOR position

Vehicle finder function

Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30
feet (10 meters) of the vehicle, pressing
the " " button three times in a five-sec-
ond period will cause your vehicle's horn
to sound once and its turn signal lights to
flash three times.
NOTE
If the interval between presses is too
short when you press the " " button
three times, the system may not re-
spond to the signals from the remote
transmitter.

Sounding a panic alarm

To activate the alarm, keep the "
ton pressed for more than two seconds.
The horn will sound and the turn signal
lights will flash.
To deactivate it, press any button on the
remote transmitter. Unless a button on the
remote is pressed, the alarm will be deac-
tivated after approximately 30 seconds.
Selecting audible signal op-
eration
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Do the following to deactivate the audible
signal. You can also use the same steps
to restore the function.
1. Sit in the driver's seat and shut all
doors and the rear gate.
2. Open the driver's door, then remove
the key from the ignition switch.
3. Hold down the "UNLOCK" side of the
power door locking switch.
4. While holding down the "UNLOCK"
side of the power door locking switch, in-
sert the key into the ignition switch and re-
move it again at least 6 times within 10
seconds after Step 3.
5. While still holding down the "UNLOCK"
side of the power door locking switch,
close the driver's door once within 10 sec-
" but-
onds after Step 4.
6. The turn signal lights flashes 3 times to
indicate completion of the setting.
NOTE
If you do not close the driver's door
within 10 seconds after Step 4, a flash
of the turn signal lights will signal time-
out. If this happens, repeat the whole
procedure from Step 1.
You may have the above settings done by
your SUBARU dealer.

Replacing the battery

Do not let dust, oil or water get on
or in the transmitter when replac-
ing the battery.
Be careful not to damage the
printed circuit board in the trans-
mitter when replacing the battery.
When the transmitter battery begins to get
weak, transmitter range will begin to de-
crease. Replace the battery as soon as
possible.