Chassis Assembly (Chassis, Enclosure Backplane, And Vpd Card) - IBM 5786 Removal And Replacement Procedures

1. Align the SCSI repeater card with its slot
in the system unit.
2. Make sure that the locking latch (B) is
raised in the unlocked position.
3. Push the SCSI repeater card fully into the
system.
4. Make sure that it is fully seated, with a
firm connection to the disk drive
backplane.
5. Push down on the locking latch (B) to
secure the SCSI repeater card in position.
6. Reconnect the SCSI cable (A) to the SCSI
repeater card in the attached server.
4. Restart the adapter. See Installing PCI adapters.
5. For 7031-D24 or 7031-T24, go to "MAP 2410: 7031-D24 or 7031-T24 repair verification" on page 42 to
verify the repair. For a server level repair verification, go to your host server's service guide. This
completes this procedure.

Chassis assembly (chassis, enclosure backplane, and VPD card)

Provides instructions for exchanging the chassis assembly. The chassis assembly for this I/O enclosure
consists of the chassis, backplane and VPD card.
To install a new chassis assembly, refer to the installation instructions that are packaged with the new
chassis. After following the removal and replacement procedures for the chassis assembly, ensure that
you go to "MAP 2410: 7031-D24 or 7031-T24 repair verification" on page 42 to verify the repair. For a
server level repair verification, go to your host server's service information. This completes this
procedure.
5786, 5787, 7031-D24, and 7031-T24 removal and replacement procedures
25