Saab 2004 9-3 Owner's Manual page 85

When the engine is started, the function that
was selected when the engine was
switched off is displayed, with the following
exceptions:
• Temp is displayed if the outside tempera-
ture is between 26 and 38°F (–3 and
+3°C).
• D.T.E is displayed if less than or equal to
30 miles (50 km).
Outdoor temperature
The Temp function is always activated
(even in NIGHTPANEL mode) if the outdoor
temperature rises or falls to between 26 and
38°F (–3 and +3°C).
WARNING
Remember that roads can be icy even at
temperatures of above 38°F (+3°C),
especially on bridges and stretches of
road that are sheltered from the sun.
Setting values
1 Select one of the functions using the
INFO dial.
• Speed W (preset to 55 mph (90 km/h)
• Dist (preset to 100 miles (100 km) if not
previously set)
• Speed Ø
• Arriv
• Date
2 Press and hold the INFO dial until given
audible confirmation.
3 Turn the INFO dial to change the value.
(Press CLEAR to reset the value.)
4 Press the INFO dial to finish setup.
Using DIST as a trip meter
1 Select Dist using the INFO dial.
2 Press and hold the CLEAR button for
approx. 1 second.
An arrow will now appear on the right-hand
side of the display, indicating that the trip
meter is running.
Instruments and controls
Resetting a single function
1 Select the function you wish to reset with
the INFO dial.
• Fuel Ø
• Speed Ø
• Trip (Dist used as trip meter)
2 Press and hold the CLEAR button for
approx. 1 second.
The selected function will now be reset.
Resetting the trip computer
1 Select one of the functions using the
INFO dial.
• Fuel Ø
• Speed Ø
• D.T.E.
• Arriv
• Trip (Dist used as trip meter)
2 Press and hold the CLEAR button
(approx. 3 seconds) until audible confir-
mation is given.
85