Saab 2003 9-5 2.3 Turbo Ecopower Owner's Manual page 85

To program a function or to cancel a programmed function, press
and hold in the relevant button until the corresponding symbol has
flashed four times on the display and a chime has sounded.
Make sure the ignition is ON.
Function Text displayed on SID
during programming
ACC: LO TEMP
A/C CTRL
ACC: RECIRC
ACC: SPEED CTRL
ACC: AUTO
RDEFR CTRL
Example: To have the ACC system switch the heating for the rear
window and door mirrors ON/OFF automatically, press and hold in
until the symbol has flashed four times on the display and a
chime has sounded.
The display shows:
ACC: AUTO
RDEFR CTRL
Once a function has been recorded under "Programming II", it will
remain in the system until you cancel the program.
AUTO will still show on the display after a function has been saved
in "Programming II".
Text displayed on SID
when cancelling
program
ACC: NORMAL
A/C CTRL
ACC: RECIRC
ACC: NORMAL CTRL
ACC: MANUAL
RDEFR CTRL
Instruments and controls
Calibration
If the battery has been disconnected or has died, the system will
need to be recalibrated.
To start the calibration procedure:
1 Start the engine.
2 Press and
Calibration takes about 30 seconds. During this time and for about
3 seconds after the operation has been completed, the number of
fault codes (if any) stored in the system will appear in the tempera-
ture display on the left. The fault codes themselves will be shown in
the temperature display on the right.
Useful tips
(Before driving the car to an authorized Saab dealer)
• If AUTO is not shown on the display, see "Cancelling the pro-
grammed settings (I)" on page 83.
• If you suspect that the ACC system is not functioning properly,
cancel (delete) all programmed settings and then recalibrate the
system.
See "Cancelling the programmed settings (I) and (II)", pages 83
and 84, and "Calibration" above.
Note that AUTO will show on the display even if you have com-
pleted Programming II, but that this does not apply to Program-
ming I.
• If the battery has been disconnected or has died, the ACC system
will need to be recalibrated. See "Calibration" above.
simultaneously.
85