Saab 2003 9-3 Owner's Manual page 126

126 Starting and driving
NOTICE
• If the engine sounds strange there is a
malfunction. Contact a Saab dealer
immediately.
• The use of fuel with too low an octane
rating can cause serious engine
damage.
Limp-home
The engine management system has a
diagnostic feature that checks a number of
internal functions. If a fault is detected in the
throttle valve, the engine management
system will set the throttle system to the
limp-home mode. This means:
• idling control will be poor (uneven idling
since regulated by ignition and fuel
supply)
• engine performance will be reduced
• the cruise control will not function
• the capacity of the A/C compressor will be
limited.
If the diagnosis function detects a fault in the
engine management system, the
"Engine malfunction (CHECK ENGINE)" in
the instrument panel will come on (see page
55). Have the car checked at a Saab dealer
as soon as possible.
The following message is shown on the SID:
Reduced engine power.
Contact Saab dealer.
NOTICE
If "Engine malfunction (CHECK
ENGINE)" warning light starts to flash
(indicating that the engine is misfiring and
the catalytic converter can be damaged),
ease off the accelerator slightly. The light
should go out or start to shine constantly.
If the light continues to flash despite
easing off the accelerator, you may
continue to drive the car but at the mini-
mum throttle permitted by the current traf-
fic situation. Have the car checked as
soon as possible at a Saab dealer.
Important considarations with
catalytic converters
light
The catalytic converter is an emission con-
trol device incorporated in the car's exhaust
system. It consists of a metal canister with a
honeycomb insert, the cells of which have
walls coated in a catalytic layer (precious
metal alloy).
NOTICE
Use only unleaded gasoline. Leaded
gasoline is detrimental to the catalyst and
oxygen sensor and will seriously impair
the function of the catalytic converter.
To ensure that the catalytic converter con-
tinues to function properly, and also to avoid
damage to the converter and its associated
components, the following points must be
observed: