D.2
DI/O Programming
GENE-SKU6 utilizes FINTEK F81866D chipset as its Digital I/O controller. Below are the
procedures to complete its configuration and the AAEON initial DI/O program is also
attached, based on which you can develop customized program to fit your application.
There are three steps to complete the configuration setup:
(1) Enter the MB PnP Mode
(2) Modify the data of configuration registers
(3) Exit the MB PnP Mode. Undesired result may occur if the MB PnP Mode is not exited
normally.
Appendix D – Digital I/O Ports
111