Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer; Flash-To-Pass - Pontiac 2008 Vibe Owner's Manual

Turn and Lane-Change Signals

The turn signal has an upward (for right) and a
downward (for left) position. These positions allow
you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will return
automatically.
To signal a lane change, raise or lower the lever until
the arrow starts to flash. Hold it there until you complete
your lane change. The lever will return by itself when
you release it.
If you signal a turn or a lane change and notice the
arrow flashing rapidly, a signal bulb may be burned
out and other drivers will not see your turn signal.
If a bulb is burned out, have it replaced to help avoid an
accident. If the arrows do not go on at all when you signal
a turn, check for burned-out bulbs and then check the
fuse. See Fuses and Circuit Breakers on page 5-91.
3-8
An arrow on the instrument
panel cluster will flash in
the direction of the turn or
lane change.

Headlamp High/Low-Beam Changer

The headlamps must be on for this feature to work.
For high beams, push the turn signal lever away
from you.
It will go off when you switch to the low beams.
To switch back to low beams, pull the lever toward you.

Flash-to-Pass

With the lever in the low-beam position, pull the lever
toward you to momentarily switch to high beams
(to signal that you are going to pass). If you have the
headlamps on when you release the lever, they will
return to the low beams.
When the high beams
are on, this light on the
instrument panel cluster
also will be on.