Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Pontiac 2006 Torrent Owner's Manual

Turn and Lane-Change Signals

The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will return
automatically.
To signal a lane change, raise or lower the lever until
the arrow starts to flash. Hold it there until you complete
the lane change. The lever will return by itself when
you release it.
As you signal a turn or a lane change, if the arrows
flash rapidly, a signal bulb may be burned out and
other drivers won't see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows do not go on at all when you
signal a turn, check the fuse, see Fuses and Circuit
Breakers on page 5-83 and for burned-out bulbs.
3-8
An arrow on the
instrument panel
cluster will flash in
the direction of the
turn or lane change.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high or
high beam to low, pull the turn signal lever all the way
towards you. Then release it.

Flash-to-Pass

This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high-beam headlamps come on, then
release the lever to turn them off.

Windshield Wipers

Be sure to clear ice and snow from the wiper blades
before using them. If the wiper blades are frozen to the
windshield, gently loosen or thaw them. If the blades do
become damaged, install new blades or blade inserts.
See Windshield Wiper Blade Replacement on page 5-45.
When the high beams
are on, this light on
the instrument panel
cluster will also be on.