Table of Contents
Advertisement
When selecting "Single Cable System" in
Step 6.
1 Select the "Single Cable Version".
Single Cable Version
Single Cable
Single Cable 2.0 (JESS)
Single Cable - EN50494:
Allow up to 8 user bands
Single Cable 2.0 (JESS) - EN50607:
Allow up to 32 user bands
Select
Confirm
RETURN
• Select the setting that matches the version of
your equipment.
• Check the Single Cable Version setting in
advance.
e.g.,
Unicable II
2 Make the settings of user band.
User Band Settings
Start Auto Setup
Please confirm user band settings before starting Auto Setup.
Tuner 1
User Band
User Band Frequency
User Band PIN
Tuner 2
User Band
User Band Frequency
User Band PIN
Select
OK
RETURN
C1
1284 MHz
Off
C2
1400 MHz
Off
• User Band
You can set C1 to C8. (If you have selected
"Single Cable 2.0 (JESS)", a value from C1
to C32 can be set.) Set to a User Band not
used by any other device.
• When only one User Band of the Router is
assigned, set "Tuner 2" to "OFF". Note that
you will not be able to record two
programmes simultaneously.
• User Band Frequency
Set the User Band Frequency with number
buttons.
• User Band PIN
If the single cable router requires a PIN to
access an user band, enter the PIN.
• For details, read the manual of the single
cable router, etc.
3 Select "Start Auto Setup", then press [OK].
• Set User Band as required.
• Refer to the operating instructions for your single cable
router for information about each item.
19
TQBS0037
Advertisement
Table of Contents
