Windshield Washer Fluid; Adding Washer Fluid - Pontiac 2001 Montana Owner's Manual

How to Check Power Steering Fluid
Turn the key off, let the engine compartment cool down,
wipe the cap and the top of the reservoir clean, then
unscrew the cap and wipe the dipstick with a clean rag.
Replace the cap and completely tighten it. Then remove
the cap again and look at the fluid level on the dipstick.
When the engine compartment is hot, the level should
be at the "H" mark. When it's cold, the level should
be at the "C" mark. If the fluid is at the ADD mark,
you should add fluid.
What to Use
To determine what kind of fluid to use, see
"Recommended Fluids and Lubricants" in the Index.
Always use the proper fluid. Failure to use the proper
fluid can cause leaks and damage hoses and seals.

Windshield Washer Fluid

What to Use
When you need windshield washer fluid, be sure to read
the manufacturer's instructions before use. If you will be
operating your vehicle in an area where the temperature
may fall below freezing, use a fluid that has sufficient
protection against freezing.

Adding Washer Fluid

Open the cap labeled WASHER FLUID ONLY. Add
washer fluid until the tank is full.
The windshield washer
fluid reservoir is located
on the passenger's side of
the engine compartment,
near the fuse and relay
center. See "Engine
Compartment Overview"
in the Index for more
information on location.
6-27