Indoor Monitoring - JVC GZ-RX625 Detailed User Manual

Using Wi-Fi by Creating a QR Code
3
The recording screen is displayed.
.
4
Operate from a smartphone
.
How to operate from a smartphone
0
"Using Smartphone Applications" (A p. 114)
136

INDOOR MONITORING

Setting (Once setting is done, start from the "Regular
o
Operation" below)
Creating a QR Code
Enter values in the required items for indoor monitoring.
o
For indoor monitoring, it is not necessary to perform settings other than
0
the password and HTTP port.
Items other than the above mentioned are used for "OUTDOOR
MONITORING". When using outdoor monitoring, enter each item and
perform the settings again.
If connection fails, check that the contents entered for each item are
correct, regenerate the QR code and set the camera.
Password: set a password to connect this camera to the device via an
0
access point. (Not more than 8 characters)
DDNS: Set the connection environment to the internet. Set to OFF when
0
outdoor monitoring is not used.
User name (DDNS): set an user name for the obtained DDNS account.
0
Password (DDNS): set a password for the obtained DDNS account.
0
UPnP: Set to "ON" if the UPnP protocol may be used to connect the device
0
to the network.
HTTP Port: Set the port number for connecting to the internet. Normally
0
set to "80".
Display the screen for reading the QR code.
1
Tap "MENU".
(Operation on this camera)
≪PLAY
.
The top menu appears.
0
2
Tap the "Wi-Fi" (Q) icon.
(Operation on this camera)
TOP MENU
Wi-Fi
OFF
SETUP
.
3
Tap "Wi-Fi SETTING".
(Operation on this camera)
Wi-Fi
DIRECT
CONNECTION
.
REC MENU
RECORD
SETTING
CONNECTION
SETTINGS
ACCESS POINT
CONNECTION
Wi-Fi SETTING