Updating Of Property Data (Function Code 68) - Brother MFC5890CN Service Manual

9.4.21 Updating of Property Data (Function code 68)

Function
To keep the print quality, the controller optimizes the drive conditions of individual head/
carriage units according to the property data. For instance, the controller optimizes the head
drive strength, ink jet-out timing and other drive conditions according to the electromechanical
properties unique to individual head/carriage units and ambient temperature.
The property data is stored in the EEPROM on the main PCB and its property code is printed on
the property labels attached to the machine and the head/carriage unit.
If you replace the head/carriage unit with a new spare part, you need to enter its property code
printed on the property label (that comes with the new spare part) and replace the old property
label on the machine (see
may be used in future, store the old property label also with the old part.
Operating Procedure
(1) Press the 6 and 8 keys in this order in the initial stage of the maintenance mode.
(2) Press the 2, 5, 8, and 0 keys in this order.
The current property data stored in the EEPROM appears on the LCD and the machine is
ready for entry.
(3) Check the property label that comes with a new head/carriage unit and then enter the
property code.
The code to be entered is 13 digits excluding the heading alphabets.
If the customizing code contains letters "A" through "F," press the 1 through 6 keys while
holding down the # key, respectively.
(4) Press the OK key.
The machine beeps, shows the "INPUT ACCEPTED" on the LCD, and writes the entered
property code into the EEPROM. Then it returns to the initial stage of the maintenance
mode.
NOTE: If the entered data contains any checksum error, the machine beeps, shows the
"INPUT ERROR" and returns to the ready-to-enter state. Go back to step (3).
Appendix 1 for the label location) with the new one. If the old part
ALR
7765501200000
9-43
Head property code
Confidential