Configuration; Configure Device Wifi - Energy GBL5.8K3 Manual

connecting batteries in parallel.
NOTICE
In parallel connect mode, Follow the request of AS 5139, except the
bipolar breaker between the battery and inverter, a bipolar breaker
between each two parallel battery systems was required to install, and the
breaker's min. current should be over 125A or following with local
regulations, for this situation, altering the proprietary battery link cables
is necessary, and altering the proprietary battery link cables will not void
the product warranty.
NOTICE
Before two or more batteries installed in parallel, please check the
voltage of each battery and make sure the voltage different less than
1.0V.

6. Configuration

6.1 Configure device WIFI

The GS ENERGY battery has a built-in WIFI module for use with the GS ENERGY
APP.
Press and hold the panel button on the side of the unit for about 4s, after the four
1.
indicator lights on, release the panel button
2. Connect the "USR-WIFI232-XX_XXXX" with your smart phone, and then the
light of WIFI will turn on by itself within 5 seconds
3. Open the APP monitor of battery, select "Confi g Device Wifi " option box.
- 21 -