STEP 11
PROBE CALIBRATION
Follow the steps to calibrate your bed leveling probe - MatterControl
will guide you through the process.
This step sets the distance of the probe from the bed and is only
performed once.
You will need a piece of paper to complete this step. Place the paper
between the nozzle and the bed. Use the controls to move the nozzle
up and down until it gently grabs the paper.
STEP 12
BED LEVELING
MatterControl will guide you through the process of Automatically
leveling the bed. (A)
Select the material you will be printing with first. We recommend
using the PRO Series Filament that came with your Pulse (you do not
need material loaded yet). (B)
The bed will begin heating. For best calibration results, wait until the
bed has reached the target temperature before proceeding. (C)
You do not need to probe the bed before every print. MatterControl
stores the probing data and applies it to every print until you change it.
Because the bed expands with heat, we recommend probing the bed
any time you change the bed temperature by more than 10C.