Moving, Placement - Siemens GEAFOL Operating Instructions Manual

GEAFOL- / CARECO-Cast-resin Transformer/ Operating Instructions
Unloading and lifting with
5.3
forklift truck
When using a forklift truck, insert the forks into the trans-
port bridges of the transformer.
NOTICE!
If signs prohibiting transport by forklift are at-
tached near the bottom of the transformer, trans-
port of the transformer by forklift is absolutely
prohibited!. Forklift transports are only permitted
if the transporter ensures that
 the transformer is moved horizontally (Fig. 5-5)

the transformer is adequately secured against the risk
of tipping and/or falling and

damage to the iron core between the core frames and
any attached accessories like fans or grounding
switches is reliably prevented.

Moving, placement

5.4
If a transformer is moved on its transport wheels, the pul-
ling lugs in the lower core frames are to be used as points
of application (see figure 5.6).
The drawbar between the towing vehicle and the transfor-
mer must be mounted as horizontally as possible (see fi-
gure 5.7).
WARNING!
Do not pull the drawbar eyes jerkily or from above. (Danger
of tipping over)
WARNING!
The centre of gravity of the transformer is in the upper
half. Make sure that you transport the transformer horizon-
tally.
WARNING!
Moving the transformer on the transport wheels is only
permitted on a firm, level surface.
NOTICE: Moving the transformer on the transport rollers is
permitted up to max. 50 m
Unpacking, examination
5.5
GEAFOL-/CARECO-transformers should be unloaded and
unpacked in a sheltered area and inspected immediately
for trans-portation damage. Any visible damage must be
noted in the transport papers and confirmed by the deliv-
erer. The sender must be informed immediately so that a
suitable claims settlement procedure can be initiated, if
necessary with the participation of the transport insurance
company.
Fig. 5-5: Horizontal transportation of trans-
former by forklift
Fig. 5-6: Pulling lugs in lower core frame
Fig. 5-7: Pulling of transformer with transport wheels
Storage
5.6
If the transformer is not commissioned immediately it must
be stored in a sheltered area that is dry and protected from
sunlight.
The transformer must be packed in a protective film when
being transported on-site or being stored temporarily. This
effectively prevents the ingress of dust and foreign matter.
In order to prevent condensation from forming, an ade-
quate quantity of desiccant agent (such as silica gel) must
be enclosed in the packaging.
© 2021 Siemens Energy Page 10