Jeep 2010 Patriot Owner's Manual page 326

in "Off-Road" mode and placing the shift lever in LOW
or REVERSE. Refer to "Safe Off-Road Driving" in "Start-
ing and Operating" for further information.
When HDC is properly enabled, the "Hill
Decent Control Light" in the instrument cluster
will be illuminated.
HDC has the capability to sense terrain and will only
activate when the vehicle is descending a hill. It will not
activate on level ground. If desired, HDC can be fully
deactivated by putting the vehicle into ESC "Full Off"
mode. This is done by pressing and holding the "ESC
Off" button for five seconds. Refer to "Electronic Stability
Control (ESC)" in this section of the manual.
HDC operation can be overridden with brake application
to slow the vehicle down below the HDC control speed.
Conversely, if more speed is desired during HDC control,
the accelerator pedal will increase vehicle speed like
normal. When either the brake or the accelerator is
released, HDC will control the vehicle back to the origi-
nal set speed.
HDC is only intended for low speed off-road driving. At
vehicle speeds above 31 mph (50 km/h) HDC will no
longer function. If the "HDC Indicator Light" begins to
flash this indicates that the brakes are getting too hot and
the vehicle should be stopped to allow the brakes to cool.
WARNING!
HDC is only intended to assist the driver in control-
ling vehicle speed when descending hills. The driver
must remain attentive to the driving conditions and
is responsible for maintaining a safe vehicle speed.
STARTING AND OPERATING 325
5