Setup Instructions - Serene SEREONICALERT CA-360Q User Manual

SETUP INSTRUCTIONS

Voice Announcement Language Selection
01.
Press the MODE button for about 3 seconds. The display will
show the available language list with the current language selec-
tion highlighted.
Use the
02.
If no voice speech is preferred, select Off from the list. The
speech icon with an "X" will be shown for no voice announce-
ments.
If there are remote receivers in the system, the remote receiver.
03.
language will be updated as well.
Quick Self-Test
01.
Press SOS button once on top of the unit. Verify that alert
outputs (speaker, voice, flasher, shaker and alert icon display)
lasts for about 45 seconds, then stops.
Pressing the RESET button will stop the alert.
02.
Verify that the flasher can be toggled ON and OFF using the
03.
RESET button.
Set the Clock
Press the (UP) button for 2 seconds to start.
01.
Use the
02.
Use the
the minutes. The hours and minutes will continue to scroll when
you press the buttons.
Press MODE or RESET button when finished. Clock is set.
03.
Clock Display ON/OFF
01.
You can turn OFF the clock display by pressing the
for 2 seconds or until you hear a beep.
02. When the clock display is off you can Press the
to display the date and press it again to display the time
momentarily.
03. To enable the clock display again, press the
until you hear a beep.
Copyright 2020 Serene Group, Inc. All rights reserved.
or buttons to scroll and press MODE again to select.
or buttons to select 12/24 format, then press MODE.
button to change the hour, and the
EN
button to change
button
button once
for 2 seconds or
12.