Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Datavideo CM-10
Summary of Contents for Datavideo CM-10
- Page 1 CM-10...
-
Page 2: Table Of Contents
Disclaimer of Product & Services The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete. -
Page 3: Warranty
Warranty Standard Warranty Datavideo equipment is guaranteed against any manufacturing defects for one year from the date of purchase. The original purchase invoice or other documentary evidence should be supplied at the time of any request for repair under warranty. -
Page 4: Three Year Warranty
Non-PCIe Card and third party provided PC components are covered for 1 year. The three-year warranty must be registered on Datavideo's official website or with your local Datavideo office or one of its authorized distributors within 30 days of purchase. Disposal... -
Page 5: Introduction
Introduction CM-10 is a ceiling mount designed for PTR robotic pan tilt head, securing your PTR robotic pan tilt head to the ceiling. Parts Assembly and Installation In this section, you will be shown how you can assemble and install your CM-10. -
Page 6: Procedure
Procedure Follow the steps outlined below to assemble the ceiling and camera mounts and secure them to your PTR robotic pan tilt head. 1. Secure the ceiling mount bracket B to the ceiling. Ceiling Ceiling Mount Bracket (B) - Page 7 The dimensions diagram of the ceiling mount bracket B is shown below. If your ceiling is made of concrete, then on the surface where the PTR robotic pan tilt head is to be installed, drill six holes spaced according to the dimensions indicated in the diagram above (enclosed by six rectangles) then use the six expansion bolts in your product package to secure the ceiling mount bracket B to the ceiling.
- Page 8 2. Assemble the camera mount Bottom upper row M3 x 6mm screws Camera Mount Arm (Silver) Camera Mount Base Bottom lower row M4 x 9.6mm screws (silver)
- Page 9 3. Secure the camera mount to the PTR robotic pan tilt head. These are the screws unloaded from PTR robotic pan tilt head.
- Page 10 4. Secure the ceiling mount bracket A to the base of the PTR robotic pan tilt head. Ceiling Mount Bracket (A) M3 x 6mm Screws (Black)
- Page 11 5. As shown in the diagram, push the ceiling mount bracket A along with the PTR robotic pan tilt head into the ceiling mount bracket B secured to the ceiling then backwards until the two brackets click into place. Ceiling...
- Page 12 6. Insert the four M4 x 8mm screws (black) into each of the four holes in the four corners of the ceiling mount bracket A then tighten.
- Page 13 7. Finally secure your camera to the camera mount base as shown in the diagram below. Place the camera here.
-
Page 14: Frequently Asked Questions
Frequently Asked Questions This section describes problems that you may encounter while using CM-10. See related items for suggested solutions. If problem still exists, please contact your distributor or the service center. No. Problems Solutions The bubble level meter of... -
Page 15: Specifications
Camera Mount Weight: 0.51 kg (1.12 lb) Specifications Model No. CM-10 Name Professional Ceiling Mount for Robotic Pan Tilt Head Weight Ceiling Mount: 1.66 kg (3.66 lb) Camera Mount: 0.51 kg (1.12 lb) Dimensions Ceiling Mount: 208 x 221 x 35 (mm) Camera Mount: 170 x 141 x 226 (mm) Max. -
Page 16: Service And Support
Datavideo Technologies Co., Ltd. All rights reserved 2020 Jul-14.2021 Ver:E1...