Replacement Bulbs - GMC 2006 Canyon Owner's Manual

To replace one of these bulbs, do the following:
1. Open the tailgate. See Tailgate on page 2-9 for
more information.
3. Pull out the lamp assembly.
4. Turn the bulb socket counterclockwise to remove it
from the taillamp housing.
5. Pull the old bulb straight out from the socket.
6. Press a new bulb into the socket and turn the socket
clockwise into the taillamp housing until it is tight.
7. Reinstall the rear lamp assembly and tighten the
screws.
5-52
2. Remove the two rear
lamp assembly screws
near the tailgate latch.

Replacement Bulbs

Exterior Lamp
Center High-Mounted
Stoplamp (CHMSL)
Headlamps
Composite High-beam
Composite Low-beam/Daytime
Running Lamp (DRL)*
Sealed-beam
Parking/Front Turn Signal/Daytime
Running Lamp (DRL)*
Parking Lamp (Inboard)
Stoplamp, Rear Turn Signal,
Taillamp, and Back-up Lamp
*Your vehicle may have the DRL function either in the
low-beam headlamp or the parking lamp.
For replacement bulbs not listed here, contact your
dealer.
Bulb Number
912
9005
9006
H6054
3757KA
3157A
3057