Removing The Bench Seat - GMC 2003 Yukon Owner's Manual

To return the seat to the seating position do the
following:
1. Push forward on the seat and release the support
lock rod.
2. Secure the support rod in its stored position on the
underside of the seat.
3. Lower the seat to the floor and let the seat drop
into place.
4. Lift up on the carrying handle to make sure the seat
is locked in place.
5. Return the seatback to the upright position by
pulling up on the release lever labeled 1 before
the back can be folded upright.
6. Pull the seatback forward to make sure it is locked
in place.

Removing the Bench Seat

To remove the full bench seat, do the following:
1. Open the rear doors and enter the rear of the
vehicle.
1-18
2. Fold the seatback
forward onto the seat
cushion by using
the lever labeled 1.
The seat cannot
be removed unless the
seatback is folded.
3. To unlatch the seat
from the floor, pull up
on the release
lever labeled 2, located
at the rear of the
seat, and lift the rear of
the seat up off the
floor.