Ford 2009 Flex Owner's Manual page 163

Memory seat/power mirrors/adjustable pedals (if equipped)
This system allows automatic
positioning of the driver seat,
outside rearview mirrors and
adjustable pedals to two
programmable positions.
The memory seat control is located
on the driver door.
• To program position one, move the driver seat, exterior mirrors and
adjustable pedals to the desired positions using the associated
controls. Press and hold control button 1 for at least two seconds.
• To program position two, repeat the previous procedure using control
button 2.
• A tone will be heard when the memory save is complete.
A position can only be recalled when the transmission gearshift is in Park
(automatic transmission). A memory seat position may be programmed
at any time.
The memory seat positions are also recalled when you press your remote
entry transmitter (unlock) control and the transmitter is
programmed to a memory seat position or when you enter a valid
customer code 1 or 2 on the keypad.
To program the memory seat to remote entry transmitter, refer to
Remote entry system in the Locks and Security chapter..
Note: The seat will not travel to its final position if the key is not
in the ignition and the easy entry feature is enabled.
Easy entry/exit feature (if equipped)
This feature automatically moves the driver's seat rearward 2 in (5 cm)
when:
• the transmission is in N (Neutral) or P (Park)
• the key is removed from the ignition
The seat will move to the original position when:
• the transmission is in N (Neutral) or P (Park)
• the key is placed in the ignition.
The easy entry feature can be turned off or on through the vehicle
message center. Refer to Message center in the Driver controls chapter.
2009 Flex (471)
Owners Guide, 2nd Printing
USA (fus)
Seating and Safety Restraints
163