Location 4 Programming The Event & Time For Output C; Locations 6 & 7 Reserved; Location 4 - GE NetworX Series Installation And Startup Manual

Remote power supply

Hide thumbs Also See for NetworX Series:

Table of Contents

Segment 2 selects the following partitions:

1 = "On" if the event should activate when it occurs in Partition 1.

2 = "On" if the event should activate when it occurs in Partition 2.

3 = "On" if the event should activate when it occurs in Partition 3.

4 = "On" if the event should activate when it occurs in Partition 4.

5 = "On" if the event should activate when it occurs in Partition 5.

6 = "On" if the event should activate when it occurs in Partition 6.

7 = "On" if the event should activate when it occurs in Partition 7.

8 = "On" if the event should activate when it occurs in Partition 8.

(2 segments of numerical data)

Segment 1 is used to program the particular event that will trigger Output C. Refer to Table XII:1 on page 11 for

the specific events that can be selected.

Segment 2 is used to select the amount of time an output will remain activated when an output triggers. If this

location is programmed as a zero, the output will follow the particular event.

LOCATION 5

(2 segments of feature selection data)

Segment 1 selects the following special conditions:

1 = "On" if output should time in minutes; "Off" if output times in seconds.

2 = "On" if output should latch until a code is entered; "Off" for timed.

3 = "On" if output should stop time when a code is entered.

4 = "On" for inverted output.

5 = "On" disables output during listen-in (only events 12-16).

6 = Reserved.

7 = Reserved.

8 = Reserved.