Table of Contents
Advertisement
1. Run AutoCAD 386(protect mode) to ensure that it is properly
installed on your system. Note the location of the AutoCAD
program files before you start the mach64 installation
program. you will need this information later.
2. Run the mach64 installation program and select DRIVER
INSTALLATION from the Main Menu.
3. From the list application, select AutoCAD. when asked for
the source driver and directory, type in the information and
insert the requested diskettes. When the Menu appears, select
READ INSTALLATION NOTES for help and tips on the
installation.
4. follow instructions on the screen to install the enhance driver.
5. When driver installation is completed, exit the installation
program. Refer to the README.DLD files that has been
copied into your AutoCAD directory for instructions and
driver configuration details.
6. Run ADIACAD.BAT to "set" the necessary driver
parameters in the DOS environment as follows:
ADIACAD<Enter>
ADIACAD.BAT was created by the mach64 installation
program for your convenience. The parameters it sets must
be in the DOS environment before you start AutoCAD.
Tip:if you are already using a batch files to start AutoCAD,
consider adding the contents of ADIACAD to your batch file.
7. Start AutoCAD and re configure AutoCAD to use the new
enhanced display list driver, Please refer to your AutoCAD
manuals for information on how to select/change a video
driver.
IBM OS/2 2.1, Warp 3.0
The mach64 accelerator hardware must be currently
configured before attempting driver installation. if necessary,
Advertisement
Table of Contents
