Equipment Board Floor Stand C - Loewe Floor Stand C Installation Instructions Manual

16
B
17
A
18 18
34857_000_Floor_Stand_C32_C40_26_08_10_GB_F_E.indd 18 34857_000_Floor_Stand_C32_C40_26_08_10_GB_F_E.indd 18
S
Installation

Equipment Board Floor Stand C

First remove the LOEWE. trim (Figure 16, arrow B) on the weight
of the fl oor plate. Use the provided suction cup for this (Figure 16,
arrow S). Place it on the trim and pull up the trim on the suction cup.
It is no longer required for installation.
Place the provided adapters (Figure 17, arrow A) on the weight of the
tubular support frame clamp. Ensure that the fi xing pin of the adapter
faces downward when inserting into the corresponding hole.
Take the Equipment Board. Place it on the adapters as shown in
Figure 17. When installing, place the Equipment Board such that
screws can be completely lowered into the holes.
Turn both the screws in with the wrench provided (T30). Tighten
them with a torque of approximately 3 Nm.
13.09.2010 08:30:53 13.09.2010 08:30:53