Init Display First
PCI Slot
AGP
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or
multiple sector read/write. If your IDE hard drive supports block mode (most
new drives do), select Enabled for automatic detection of the optimal number
of block read/writes per sector the drive can support. The settings are:
Enabled, Disabled.
Power On Function
This function allows you to select the item to power on the system.
The settings are : Any Key, Button Only, Mouse Left, Mouse Right,
Password, Hotkey, keyboard 98.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD)
installed on the system board and you wish to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field.
The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and
second serial ports. The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
If both PCI VGA card and AGP card are
installed, the system will display the PCI
VGA card first.
If both PCI VGA card and AGP card are
installed, the system will show the AGP
card first.
3-17
®