Starting And Operating Your Vehicle; New Vehicle Break-In - Chevrolet 2006 Malibu Owner's Manual

4. Insert the key to be programmed and turn it to on
within five seconds of removing the original key.
5. The security light will turn off once the key has
been programmed. It may not be apparent that
the security light went on due to how quickly
the key is programmed.
6. Repeat Steps 1 through 5 if additional keys are
to be programmed.
If you are ever driving and the security light comes on
and stays on, you may be able to restart your engine if
you turn it off. Your PASS-Key
is not working properly and must be serviced by
your dealer. Your vehicle is not protected by the
®
PASS-Key III + system at this time.
If you lose or damage your PASS-Key
see your GM dealer or a locksmith who can service
®
PASS-Key III + to have a new key made.
2-22
®
III + system, however,
®
III + key,
Starting and Operating Your
Vehicle

New Vehicle Break-In

Notice: Your vehicle does not need an elaborate
break-in. But it will perform better in the long run if
you follow these guidelines:
•
Do not drive at any one constant speed, fast or
slow, for the first 500 miles (805 km). Do not
make full-throttle starts. Avoid downshifting to
brake, or slow, the vehicle.
•
Avoid making hard stops for the first 200 miles
(322 km) or so. During this time your new brake
linings are not yet broken in. Hard stops with new
linings can mean premature wear and earlier
replacement. Follow this breaking-in guideline
every time you get new brake linings.
•
Do not tow a trailer during break-in. See Towing
a Trailer on page 4-42 for the trailer towing
capabilities of your vehicle and more
information.
Following break-in, engine speed and load can be
gradually increased.