Chevrolet 2005 Corvette Owner's Manual page 302

8. Now connect the black negative ( ) cable to the
negative ( ) terminal of the good battery. Use a
remote negative ( ) terminal if the vehicle has one.
Do not let the other end touch anything until the
next step. The other end of the negative ( ) cable
does not go to the dead battery. It goes to a
heavy, unpainted metal engine part or to a remote
negative ( ) terminal on the vehicle with the
dead battery.
9. Connect the other end of the negative ( ) cable at
least 18 inches (45 cm) away from the dead battery,
but not near engine parts that move. The electrical
connection is just as good there, and the chance
of sparks getting back to the battery is much less.
10. Now start the vehicle with the good battery and run
the engine for a while.
11. Try to start the vehicle that had the dead battery. If
it will not start after a few tries, it probably needs
service.
Notice: If the jumper cables are removed in the
wrong order, electrical shorting may occur and
damage the vehicle. The repairs would not be
covered by your warranty. Remove the jumper
cables in the correct order, making sure that the
cables do not touch each other or other metal.
5-42
Jumper Cable Removal
A. Heavy, Unpainted Metal Engine Part
B. Good Battery
C. Dead Battery
To disconnect the jumper cables from both vehicles,
do the following:
1. Disconnect the black negative ( ) cable from the
vehicle that had the dead battery.
2. Disconnect the black negative ( ) cable from the
vehicle with the good battery.
3. Disconnect the red positive (+) cable from the
vehicle with the good battery.
4. Disconnect the red positive (+) cable from
the other vehicle.