Table of Contents
Advertisement
8.1.2.
Installation of USB-SERIAL driver
Execute the "Setup.exe" file in "ComMass" folder by double
clicking to install the USB-SERIAL driver.
8.1.3.
COM Mode
If a Disc or SD Card is inserted, remove before operation.
To enter the PC connection (COM) mode, push the [DELETE],
[RECORDING START/STOP] and [JOYSTICK CONTROL UP]
simultaneously
for
3
seconds
disconnected.
8.1.4.
Set up of PC-EVR Adjustment
Program
1. Turn on the PC and install the PC-EVR Adjustment
Program into the PC.
2. Execute the "kdr2007.exe" file by double clicking to start up
the PC-EVR Adjustment Program.
The main menu will be displayed.
3. Select the appropriate model.
4. Turn on the camcorder and set to PC connection (COM)
mode. Then click "Start".
5. When the communication is complete, the dialog will
appear.
Click "Yes," and "Save" to save the EEPROM data.
Fig. E2-2
with
the
USB
Cable
37
6. When EEPROM data has been saved, the menu will
appear.
To perform each adjustment, display the adjustment menu
by selecting from "Camera Adjust" or "Video Adjust" and
select each adjustment item.
Fig. E2-3
Note:
The adjusted data is stored in the EEPROM IC after
each adjustment.
7. After adjustment, to close the software, select "Exit" in the
File menu or close the window.
Fig. E2-4
8. To release the PC connection (COM) mode, push the
[DELETE], [RECORDING START/STOP] an [JOYSTICK
CONTROL UP] simultaneously for 3 seconds with the USB
Cable disconnected.
Advertisement
Table of Contents
