Panasonic VDR-D220E Service Manual page 35

17. Installation of EVF F.P.C., EVF Lock Plate, EVF Slide
Base and Shoe Angle
Take care not to damage the F.P.C. and the Switch.
1) Insert the EVF F.P.C. into the slot and secure it with the
2 pins. Then, pass it through the hole.
2) Install the EVF Lock Plate with the Locking Tab (L-2).
3) Connect the EVF F.P.C. to Connector FP8901, and
install the EVF Slide Base so that the ribs are inserted
into the slots.
4) Install the Shoe Angle with the 2 pins. Then, tighten the
Screw (533).
5) After installing, verify the EVF moves correctly.
EVF F.P.C.
Hole
Pass
EVF Lock Plate
Pin
Pin
Pin
Pin
Pin
<Bottom View>
EVF Slide Base
Ribs
FP8901
Pin
533
Pin
Fig. D16
EVF Standby
Switch
Slot
Pins
(L-2)
Pin
Rib
Slot
Shoe Angle
18. Removal of Eye Cap
Remove the Eye Cap after removing the 2 Screws (533).
19. Handling cautions of EVF Lens Unit
Use extreme care when handling the EVF Lens Unit to
avoid damage, dust, and spots (especially fingerprints,
etc.)
Installation of EVF Lens Unit, Eye Sight Lever
1) Install the Eye Sight Lever into the EVF Case hole in the
direction shown.
2) Install the EVF Lens Unit into the EVF Case.
3) After installing, verify the Eye Sight Lever and the EVF
Lens Unit work together correctly.
EVF Case
Hole
EVF Lens
Unit
35
Rotate
Eye Sight Lever
Fig. D17