Table of Contents
Advertisement
Programming the Remote Control
58
The remote control is preset to operate Sony brand video equipment.
5
Sony Equipment
DVD/VCR
SAT/Cable
If you have video equipment other than Sony brand that you want to control
with the TV's remote control, use the following procedures to program the
remote control.
3
The equipment must have infrared (IR) remote capability in
order to be used with this remote control.
4
From the "Manufacturer's Codes" listed on page 59, select the three-digit
code number for the manufacturer's code of your equipment. If more than
one code number is listed, try entering them one by one until you come to the
correct code for your equipment. Use the code number to complete the
following procedure.
1
Press the
DVD/VCR (FUNCTION)
simultaneously, or press the
buttons simultaneously. DVD/VCR and SAT/CABLE buttons flash.
1, 2
2
Press the function button you want to program.
To program a cable box or a satellite receiver
SAT/CABLE
Press
To program video equipment
DVD/VCR
Press
3
Enter the three-digit manufacturer's code number using the
4
Press ENT.
1
5
To check if the code number works, aim the TV's remote control at the
equipment and press
corresponds with that equipment. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
If you enter a new code number, the code number you
previously entered at that setting is erased.
In some rare cases, you may not be able to operate your
equipment with the Sony remote control. In this case, use the
equipment's own remote control unit.
Programmable Code Number
601 (Sony Dream System)
801 (Sony Satellite Receiver)
and
RESET
SAT/CABLE (FUNCTION)
(FUNCTION).
(FUNCTION).
DVD/VCR
and/or
SAT/CABLE (POWER)
buttons
RESET
and
0-9
buttons.
that
Advertisement
Table of Contents
