Controls - GE ADHL22 Owner's Manual

Controls

Appearance may vary by model.
indicator
light High, Medium,
Dry indicator light
Controls
NOTE: When the bucket is full or removed, the controls
cannot be set.
1. Power Pad
2. Fan Speed Pad
Controls the fan speed.
Set the fan control to High for maximum moisture removal.
When the humidity has been reduced and quiet operation is
Smart Dry compares the set humidity level with the actual
humidity and adjusts the fan speed automatically.
3. Display
Shows the set % humidity level while setting, then shows the
actual (+/– 5% accuracy) room % humidity level.
4. Humidity Set Control Pads
set the unit for continuous operation, press the – pad until
NOTE:
continuously at its maximum dehumidification settings if
attached to a hose to drain or until the bucket is full.
– pad and set to a lower percent value.
+ pad and set to a higher percent value.
When you first use the dehumidifier, set the humidity control
to achieve the humidity level. If you still have damper air
than desired, set the humidity level to a lower setting or
Other Features
Alarm
seconds to remind you to empty and replace the bucket.
Power Outage
In the case of a power outage or interruption, the unit will
automatically restart, in the settings last used, after the power
is restored.
Delay On/Off
indicator lights
indicator light
5. Filter Timer
light will glow to remind you to clean the filter. Remove the
filter and clean it.
reminder. See the Care and Cleaning section.
6. Delay Off
While the dehumidifier is operating press the Delay button.
number of hours you want the dehumidifier to continue to
operate before turning Off.
NOTE: After displaying the time, the Display will revert to
showing the current humidity after 5 seconds have passed.
on the delay.
Delay On
While the dehumidifier is off press the Delay button.
number of hours you want the dehumidifier to remain off
before turning On.
NOTE:
unit turns on.
To cancel the Delay:
again and the Delay will be cancelled.
7. Empty Indicator
to be emptied, or when the bucket is removed and/or not
replaced in the proper position.
Auto Shut Off
when the bucket is full, or when the bucket is removed or not
replaced in the proper position. NOTE:
compressor will stop as soon as the bucket is removed. An
alarm will sound if the water level switch is not reset.
Auto Defrost
When frost builds up on the evaporator coils, the compressor
will cycle off and the fan will continue to run until the frost
disappears.
49-5000545 Rev. 0