Chevrolet 1999 Monte Carlo Owner's Manual page 105

Installation
1. Move the driver's seat to its most rearward position.
2. Place the driver's side floor mat in the vehicle with
the rear of the mat against the left (outboard)
front edge of the seat track mounting bracket
(see view A).
3. Use a screwdriver to screw the locator post into the
vehicle's carpeting. Press down while turning to
allow the locator to pierce the floor carpet. The
locator will not screw down tightly, but will rotate
freely when installed properly.
Usage
D
To remove the mat, pull up on the rear of the mat to
unsnap it from the locator post (see view B).
D
-
To re install the mat, align the grommet in the mat
over the locator post and push down to snap the mat
into place (see view B).
Auxiliary Power Connection
They are located on the passenger's side of the vehicle,
below the glove box and behind what is referred to as a
"hush panel." For additional information on accessing
these leads and electrical hookup, please refer to the
service manual.
yellowblue
Your vehicle is equipped
with auxiliary power leads.
These leads can be used to
power aftermarket electrical
equipment added to
your vehicle.
2-43