Cadillac 2007 Escalade Owner's Manual page 136

If the engine still does not start with the other key,
your vehicle needs service. If your vehicle does
start, the first key may be faulty. See your dealer
who can service the PASS-Key
key made. In an emergency, contact Roadside
Assistance.
It is possible for the PASS-Key
"learn" the transponder value of a new or
replacement key. Up to nine additional keys may
be programmed for the vehicle. The following
procedure is for programming additional keys only.
If all the currently programmed keys are lost or
do not operate, you must see your dealer or
a locksmith who can service PASS-Key
have keys made and programmed to the system.
See your dealer or a locksmith who can service
®
PASS-Key III+ to get a new key blank that is
cut exactly as the ignition key that operates
the system.
136
®
III+ to have a new
®
III+ decoder to
®
III+ to
To program the new additional key do the following:
1. Verify that the new key has a
2. Insert the original, already programmed, key in
the ignition and start the engine. If the engine
will not start, see your dealer for service.
3. After the engine has started, turn the key
to OFF, and remove the key.
4. Insert the new key to be programmed and
turn it to the RUN position within five seconds
of removing the original key.
5. The security light will turn off once the key
has been programmed.
6. Repeat Steps 1 through 5 if additional keys
are to be programmed.
If you are driving and the security light comes on
and stays on, you may be able to restart your
engine. Your PASS-Key
may not be working properly and must be serviced
by your dealer.
If you lose or damage your PASS-Key
see your dealer or a locksmith who can service
®
PASS-Key III+ to have a new key made.
1
stamped on it.
®
III+ system, however,
®
III+ key,