Setting The Digital Output Signal - Sony SMP-U10 Operating Instructions Manual

◆ DIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (COAXIAL)/HDMI OUT
jack.
ON Normally, select this position.
When you select "ON," see

"Setting the digital output signal"

for further settings.
OFF
The influence of the digital
circuit upon the analog circuit is
minimal.
Setting the digital output signal
Switches the method of outputting audio
signals when you connect a component such
as an audio component or MD deck with a
digital input jack.
For connection details, see page 11.
Select "DOLBY DIGITAL" and "48kHz/
96kHz PCM" after setting "DIGITAL OUT"
to "ON."
If you connect a component that is
incompatible with the selected audio signal, a
loud noise (or no sound) may be heard from
the speakers, risking damage to your ears or
speakers.
◆ DOLBY DIGITAL
Selects the type of Dolby Digital signal.
DOLBY Select this when the player is
DIGITAL connected to an audio
component with a built-in
Dolby Digital decoder.
D-PCM
Select this when the player is
connected to an audio
component without a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
"DOWNMIX" item in
"AUDIO SETUP" (page 24).
◆ 48kHz/96kHz PCM
Selects the sampling frequency of the audio
signal.
48kHz/16bit The audio signals of video files
are always converted to 48 kHz/
16 bit.
96kHz/24bit All types of signals including
96 kHz/24 bit are output in their
original format. However, if the
signal is encrypted for
copyright protection purposes,
the signal is only output as
48 kHz/16 bit.
b
• The analog audio signals from the LINE OUT
(L-AUDIO-R) jacks are not affected by the
"48kHz/96kHz PCM" setting and keep their
original sampling frequency level.
• If the HDMI OUT jack is connected to equipment
not compatible with Dolby Digital or 96 kHz/
24 bit signals, D-PCM or 48 kHz/16 bit PCM will
be output respectively, regardless of the settings.
US
25